Manual and rating-plate figures; engineering cells are 314Ah / 4019.2Wh, the '300Ah' tier nameplate ≈ 3840Wh. At the 3840Wh nameplate divided by the load: 100W → 38.4h, 300W → 12.8h, 500W → 7.68h, 800W → 4.8h and 1000W → 3.84h. Keep every continuous load at or below the 1280W ceiling; at the full ceiling the bank lasts ~3.0–3.14h. When running through a separate 12V inverter, derate by about 90–95% efficiency and leave depth-of-discharge headroom. The pack weighs 26kg net (27kg gross) — plan a two-person lift. The price is €369.99 EUR struck from €470.00 (21% off, Save €100.01), in stock and new. Shipping is free to 15 European countries (1–3 days handling plus 2–7 days transit), with 30-day returns by post. The warranty is 3 years against a ~10-year design life, so the covered period is shorter than the expected service life at light use. Connecting the inverter to the grid and generator has a precise procedure and switch order. Always isolate the input branches first, then connect battery, panel and AC circuit, and finally set the charge profile and parameters. Off-grid and backup mode require a clean output waveform and fast transfer time; sensitive electronics, computers and network gear need a stable wave without oscillation. Have all work checked by a qualified electrician if you do not hold the relevant competence. Safety rules for an isolated installation: never work live, protect every branch against short circuit and sparks, protect the battery against overcharge and deep discharge, and do not exceed the continuous output limit. A pure sine wave protects sensitive electronics but does not replace correct cable and fuse sizing. If you are unsure of the wiring or battery profile, use a qualified installer; a wrong install endangers equipment and safety.

314Ah engineering cells, 4019.2Wh, 100A BMS, 1280W continuous ceiling, 6000 cycles at 80% DoD, IP65, 369.99 EUR instead of 470.00 EUR.

Same 12V class; compare usable DoD energy, cycle life, weight and footprint, not just nameplate Ah. The maximum configuration is 4P4S: four in parallel times four in series = 16 units, giving 51.2V and 1256Ah for 64.3kWh. When building a bank, use units that are identical in model and matched within about one month of production / charge history; do not mix new and heavily-used units, and keep the whole bank on the 14.4V charge profile with the 10V cut-off. When designing an off-grid or hybrid system, start from real daily consumption: list every permanent and starting appliance, its rated power and run time, then build a daily energy budget in Wh. Only after that choose the inverter, PV array and battery; buying the equipment first and sizing the load later leads to undersizing or needlessly high cost. Homes, caravans, holiday cabins and workshops have different load profiles, so a generic recommendation for a fridge, pump or heat pump is always individual. Wi-Fi and monitoring let you track voltage, power, charge current and battery state directly on a phone or computer. The app shows daily gain, consumption and history, so you can spot overload or a failing cell before a fault. Daytime battery-free running with clear sun is practical, but overnight and continuous backup need the battery bank; monitoring helps distinguish array-only running from battery running.

GSIKE keeps ~4kWh, 6000 cycles and a light chassis at 369.99 EUR instead of 470.00 EUR, free delivery to 15 EU countries.

Approximate runtime at 80% DoD, nameplate 3840Wh; the BMS caps continuous discharge at 100A = 1280W. Both, for different jobs. The inside cells are engineering-rated 314Ah (12.8V × 314Ah = 4019.2Wh); GSIKE sells this in the conservative "300Ah" tier, whose nameplate is 12.8V × 300Ah ≈ 3840Wh — the figure on the marketing and runtime graphics. Use 314Ah / 4019.2Wh for spec comparisons and the 3840Wh nameplate to estimate run-time. The ~180Wh gap is tier rounding, not a second battery, and it does not change the 100A BMS, the 1280W ceiling or the 6000-cycle rating. The MPPT charge controller is the heart of solar charging: it tracks the maximum-power point of the panels and adjusts voltage so the battery receives as much energy as possible. Compare not only the total controller current but also the panel-voltage range and the module wattage it accepts; an undersized MPPT does no damage but limits array harvest. Wire panels in series or parallel so the working voltage falls inside the controller range, respecting insulation and fuses on the PV side. Maintenance extends equipment life: check terminal torque, ventilation cleanliness and cooling regularly in a dry, airy room free of damp and dust. Watch charge voltage and any cell heating, and after a few years confirm battery condition and connection tightness. Avoid high humidity, dust or frost risk; respect the operating and storage temperatures stated in the manual.

Inverter loads over 1280W continuous trip the BMS; the 400A pulse is only for short startup inrush.

Parallel adds capacity at 12.8V; series raises voltage. Match cells and balance before linking. It weighs 26kg net (27kg gross) — genuinely heavy, so plan a two-person lift and use the integrated handles when tilting it into a motorhome locker or boat compartment. Bolt it down through the base with the M8 terminals using the supplied hardware, keep it upright, leave ventilation around the ABS case and run the thick 12V cables short. Because the charge window is 0°C to 50°C, mount it where the space stays above freezing in winter; do not charge below 0°C even though discharge works down to −20°C. The battery provides the reserve for cloudy days and night operation. Its capacity is chosen from daily consumption and the desired autonomy days, respecting the depth of discharge of the chemistry. Lead-acid tolerates shallower depth and more frequent top-ups; LiFePO4 accepts deeper cycles. Regardless of chemistry, care for equal cell voltage, the correct charge profile and current sizing, because a mismatched profile shortens life more than the cycles themselves. When comparing models, match the same class: continuous kW, starting peak, MPPT current and range, acceptable PV wattage, battery input voltage, number of outputs and Wi-Fi connection. The listing name may not match true continuous power, so read the manual table and rating plate. A cheaper model with a smaller MPPT or no monitoring can behave worse under real load, so total value depends on the sum of parameters, not the ad slogan.

Scales from one 314Ah unit to balanced parallel banks; 369.99 EUR, free EU delivery, 30-day returns.

Parameters follow the manual; the spec sheet prevails on conflict. Not for a golf cart — this is a 12V leisure / deep-cycle pack, not a traction battery for the high continuous drive current of a golf-cart system. It is well suited to an electric trolling motor on a boat (several buyers report a full day on one charge), as well as campervans, motorhomes, off-grid cabins, home solar storage and camping. Cables and fuses are often underestimated but are a decisive part of a safe installation. At the battery's low voltage the current is high, so conductors must be short, thick and sized by current and length, keeping voltage drop and heating within normal limits. On every safety boundary (battery, panel, output) use a properly rated fuse and isolator switches; an undersized cable can overheat, and the fuse protects against short circuit and fire. European availability and logistics affect delivery speed and return conditions. Confirm warehouse location, estimated lead time, return rules and spare-parts/support availability before buying. Prices in EUR may be shown without hidden fees, but the final price, duties and local taxes are always confirmed by the checkout. Warranty terms and the possibility of support matter more than a single monthly discount badge.

IP65 dust and splash; sheltered solar, RV and boat use.

Use-case images in fixed order; each shows an honest European application.

Camper van

On a bench shelf it runs the fridge, water pump, heater and chargers for several days off-grid — exactly what multi-day travellers want. The GSIKE 12.8V 300Ah LiFePO4 battery stores 4019.2Wh of deep-cycle energy in a 26kg IP65 ABS case — 314Ah engineering cells (a ~3840Wh "300Ah" nameplate), a 100A BMS capped at 1280W continuous, 6000 cycles at 80% depth of discharge, a 14.4V CC/CV charge profile and expansion to a 16-unit / 64.3kWh bank, sold across Europe at €369.99 struck from a real €470.00 regular price (21% off, Save €100.01), with free delivery and a 30-day return.

Motorhome locker

Strapped into the under-seat bay, the 54 cm case fills an existing battery compartment and powers extended trips away from hook-ups. 4019.2 Wh 314 Ah (300Ah class) 100A BMS 1280W ceiling 6000 cycles 400A pulse / 1s 14.4V CC/CV IP65 M8 terminals up to 64.3 kWh bank

Forest log cabin

A remote cabin relies on it for warm light and phone power after the panels stop generating at dusk, across several cloudy days. Because LiFePO4 safely delivers close to its full capacity while flooded lead-acid is limited to about 42% depth of discharge, one GSIKE 300Ah replaces roughly six 12V 100Ah lead-acid batteries wired IN PARALLEL on the same 12V bus . Never wire them in series to make 24V — that is a different system.

Home solar storage

Mounted on a rack beside the switchgear, it stores daytime solar and covers the evening self-consumption load, expandable later. Keep every continuous load at or below the 1280W ceiling ; if you pull the full 1280W, the bank lasts ~3.0–3.14h. When running through a separate 12V inverter, derate by about 90–95% efficiency and leave depth-of-discharge headroom.

Fishing boat / trolling motor

The steady 100A discharge gives a trolling motor smooth thrust without sag — buyers report a full day of fishing on one charge. The battery supports parallel and series building. 4P4S = four in parallel × four in series: 16 units total = 64.3 kWh . 4S raises the voltage to 51.2 V ; 4P raises the capacity to 1256 Ah (51.2 V × 1256 Ah = 64,307 Wh).

Parallel battery bank

Add matched units in parallel to grow the run-time (current adds) — the path toward a 16-unit / 64.3 kWh system. These are the eight accurate official images (main unit first). Five marketing infographics are deliberately excluded: two overstate the BMS and appliance power, one overstates cycle count, one overstates the pulse current and one prints a different dimension. None of the excluded figures are used on this page.

Off-grid garden shed

On a shed shelf it cycles daily from a small solar array; the IP65 case shrugs off damp workshop air. Verbatim buyer reviews as submitted. This listing has no buyer photographs, so none are shown — the words are left to speak for themselves. The distribution is 16 five-star and 2 four-star reviews (Luc Peeters and Robert Martin), averaging 4.889, rounded to 4.9.

Workshop charging

On a workbench it charges from the 14.4V source and supplies bench lighting, pumps and chargers — the 10V cut-off protects the cells. We live in an area where storms often knock out the power for hours, and this battery has carried us through every single outage without any problems, because the 100A continuous discharge current means it can power quite demanding appliances and the surge capability handles the start-up current of the fridge without any trouble, and the IP65 waterproof rating means it can live happily in our utility room.

Official manufacturer images; the manual table prevails on conflict.

Prices in EUR; final logistics, duties and taxes are confirmed at checkout.

Read before you buy: